; PRT00201.CMD
;
; PARTICLES MODE 2 (GENERAL 2) COMMAND SET
; REQUIRES IDPU S/W MODE 2.4 OR LATER
; TURNS ON HV IF IT WAS ENABLED
; TURNS ON ESA AND TEAMS.
;
; SWEEP MODES:
;  EESA: 32 SWEEPS PER SPIN (DWELL,ACCUM=2X), 48 ENERGIES, ETOP=CCh,
;        RETRACE=0, LOW ENERGY=0
;  IESA: 32 SWEEPS PER SPIN (DWELL,ACCUM=2X), 48 ENERGIES, ETOP=CCh,
;        RETRACE=0, LOW ENERGY=0
;  SESA: CYCLE MODE, 12 ENERGIES, SEPARATION=4/48, DWELL=ACCUM=2X,
;        ETOP SET BY PEAK DETECT TRACKING
;  TEAMS: 32 SWEEPS/SPIN, DEFAULT RANGE
;  
;  SLOW SURVEY: (TEAMS MODE SS1(1), SAVG=4C, EAVG=42, IAVG=42; NOTE: DE-SPIN)
;    SESA: 16 AVERAGES/SPIN @ 12EX16A = 4.9KBPS AT 12RPM
;    EESA: 2 AVERAGE/SPIN @ 48EX32A =   4.9KBPS    "
;    IESA: 2 AVERAGE/SPIN @ 48EX32A =   4.9KBPS    "
;    TEAMS SURVEY                       3.7KBPS    "
;    TEAMS HI-MASS                      1.6KBPS    "
;    TEAMS POLE CHANNEL                 -
;    TEAMS MONITOR RATES                1.6KBPS    "
;    TEAMS PHA                          0.8KBPS    "
;                             TOTAL:   22.6KBPS    "
;
;  FAST SURVEY: (TEAMS MODE FS3A(7), SAVG=48, EAVG=40, IAVG=40; NOTE: DE-SPIN)
;    SESA: 256 AVERAGES/SPIN @ 12EX16A= 78.6KBPS AT 12RPM
;    EESA: 8 AVERAGES/SPIN @ 48EX32A =  19.7KBPS   "
;    IESA: 8 AVERAGES/SPIN @ 48EX32A =  19.7KBPS   "
;    TEAMS SURVEY                       29.5KBPS   "
;    TEAMS HI-MASS                       6.6KBPS   "
;    TEAMS POLE CHANNEL                 13.1KBPS   "
;    TEAMS MONITOR RATES                 1.6KBPS   "
;    TEAMS PHA                           6.6KBPS   "
;                             TOTAL:   175.4KBPS   "
;
;  BURST:
;   SESA: 768 CYCLES/SPIN @ 6SX2EX16A  235.9KBPS AT 12RPM
;   EESA: 32 SWEEPS/SPIN @ 48EX32A      78.6KBPS   "
;   IESA: 32 SWEEPS/SPIN @ 48EX32A      78.6KBPS   "
;   TEAMS: BURST @ 32 SWEEPS/SPIN      157.3KBPS   "
;                            TOTAL:    550.4KBPS   "
;
; DWC  3-MARCH-1995
; Revision 19-April-1995, Verion 01, DWC
;      add direct CDI register commands for ESA sweep mode so that
;      mode changes even if ESA already on.
;=====================================
MODEID = 002
SLOT = 1
CURRENT = 628
MODELOAD
CMDLOG PRT00201.LOD
.CMDS 51
;
; << START THE MODE DEFINITION >>
;
STARTDEF.CMD
;
;  Off -> Slow Survey Sequence:
;
.TABLE 0 0		;DISABLE BURST FOR 30 SECONDS
.LOAD 30
.TABLE 14 0x94		;ESA ICT, PARTICLES MODE ID
.LOAD 02
.TABLE 14 0x89		;ESA ICT, ESA_SAVG; sESA AVERAGER MODE
.LOAD 0x4C		; 16 AVERAGES/SPIN, 12E, DESPIN
.CDDB4C0F		;Direct CDI of above
.TABLE 14 0x8A		;ESA ICT, ESA_EAVG/ESA_IAVG; eESA/iESA AVERAGER MODE
.LOADW 0x4242		; 2 AVERAGE/SPIN, 48Ex32A, DESPIN
.CDDD4242		;Direct CDI of above
.TABLE 14 0X80		;ESA ICT, SWEEP MODES
.LOADW 0x25C2		; SESA: CYCLE MODE, DWELL=2X, INCREMENT=2X, DELTA=4X
.LOADW 0x01CC		; EESA: DWELL=2X, TOPE=MAX, LOWE=RETRACE=OFF, 48E
.LOADW 0x01CC		; IESA: DWELL=2X, TOPE=MAX, LOWE=RETRACE=OFF, 48E
.LOADW 0X0015		; DATAMODE: ACCUM=2X
.CDFA25C2		;Direct CDI of above
.CDFB01CC		;Direct CDI of above
.CDFC01CC		;Direct CDI of above
.CDFD0015		;Direct CDI of above
.TABLE 14 0xBC		;SESA TRACKING CONTROL
.LOAD 0xFF		; ENABLE
.LOAD 0			; MIN LEVEL (ETOP-6DELTAE)
.LOAD 0x33		; MAX ETOP (MAX)
.LOAD 1			; TRACKING OFFSET = 1xDELTAE; ONE SESA ABOVE PEAK
.DIAGREQ 1		;MAX DIAGNOSTIC RATE WHILE HV ON
.ESAHVON		;START ESA LV & HV ON SEQUENCE (NO HV IF NOT ENABLED)
.ADR 0x3CB6		;TEAMS STARTUP SEQUENCE
.LOAD 0x71		; TEAMS STARTUP MODE = 1
.TEAMS 1		;TEAMS STBY->ON 
.CMDWT 2560		;20 SECOND WAIT TO BE SURE HV ON.
.DIAGREQ 60		;SLOW DOWN DIAGNOSTIC PACKETS
;
;=============================
;  Slow Survey -> Fast Survey Sequence:
; 
;.CDDB4A0F		;sESA SURVEY -> 256 AVG/SPIN
;.CDDD4040		;eESA/iESA SURVEY -> 8 AVG/SPIN
;.CD747703		;TEAMS MODE 7
;
R0 = 6			;DEFINE FAST SURVEY PARTICLES 
DEFFASTP.CMD
.LOADW 0x480F
.LOADW 0xCDDB
.LOADW 0x4040
.LOADW 0xCDDD
.LOADW 0x7703
.LOADW 0xCD74
;
;=============================
;  Fast Survey -> Slow Survey Sequence:
;
;.CDDB4C0F		;sESA SURVEY -> 16 AVG/SPIN
;.CDDD4242		;eESA/iESA SURVEY -> 2 AVG/SPIN
;.CD747103		;TEAMS MODE 1
;
R0 = 6		;DEFINE SLOW PARTICLES
DEFSLOWP.CMD
.LOADW 0x4C0F
.LOADW 0xCDDB
.LOADW 0x4242
.LOADW 0xCDDD
.LOADW 0x7103
.LOADW 0xCD74
;
; << END THE MODE DEFINITION >>
; 
ENDDEF.CMD