spd_ui_draw_object method: setProperty Set a couple of properties related to drawing Mainly used to perform output to other devices Destination: The target to which draws will be made. Some parameters used in updated are also drawn from the destination. This should be some sort of IDLgr* destination object. LineRes: The resolution at which lines will be drawn. Ideally, this is a scalar multiple of the current screen resolution. (ie plot with 500 pixel width, and lineRes 2 will send 1000 points to the output destination) Line resolution modification is currently limited by aliasing issues. So it is ignored in the current version and all line plots send every point to the output destination. SpecRes: The resolution at which spectral plots will be drawn. SpecRes is a multiple of screen resolution. If specRes is 2 and a plot has a screen resolution of 400x300 pixels, a spectral plot of 800x600 will be output to the destination. HistoryWin: The history object that the draw object sends its history output to. statusBar: The status bar object that the draw object sends status messages to. fancompressionfactor: The percentage error to be applied to the fancompression algorithm during postscript plotting. 0 = No compression $LastChangedBy: jimm $ $LastChangedDate: 2014-02-11 10:54:32 -0800 (Tue, 11 Feb 2014) $ $LastChangedRevision: 14326 $ $URL: svn+ssh://thmsvn@ambrosia.ssl.berkeley.edu/repos/spdsoft/trunk/spedas/gui/display/draw_object/spd_ui_draw_object__setproperty.pro $